Found in 2008, We are professional industrial valves manufacturers on wellhead control.

24 hours at your service: admin@sgvalves.com

the basics of industrial high pressure relief valves

by:Sino Valves     2021-02-21
The industrial high pressure drain valve is mainly used for water or chemical tanks, which are designed to open if an overvoltage occurs inside the tank.
There are several different types of industrial high pressure safety valves at the moment, so it is very important to know exactly what you need.
This article will introduce the basics of high pressure valves in order to give you a basic understanding of what exists and how they work.
Here are two major types of industrial high pressure safety valves that you should be familiar.
Axis design-\"with non-
Through the viscous solid shaft of the three seals, the liquid is effectively isolated from the spring.
The hole of the valve is usually sealed by the seat at the end of the shaft.
The diaphragm is designed to use a diaphragm of rubber or four fluorine as a seal to isolate the spring and valve hole seals.
Probably the most popular design is a 90 degree angle with high pressure valves installed.
The simple design allows easy installation where applications are needed.
So, how do these industrial high pressure discharge valves operate?
Basically, they are usually in a closed position, but they start to open once a certain level of pressure is reached.
Spring pressure is usually used on the diaphragm or shaft.
You can usually set the required pressure level yourself by manually turning the adjusting Bolt clockwise to raise the pressure level and moving counter-clockwise to reduce the pressure level.
When the pressure reaches this level, the liquid will begin to enter the valve.
If you are using a high-pressure gas system, the gas is released into the atmosphere.
If the pressure inside the system continues to rise, allowing more liquid to escape, the valve will open further.
Next is the question of where these industrial high pressure safety valves can be used.
They can be used in various parts of the liquid storage system, no matter what, to provide many system control advantages.
Interestingly, depending on where they are installed on this system, they will have different names.
The following is a description of the different names given according to the installation location: the high-pressure valve protects the tank, pump or pipe segment from over-voltage.
The back pressure regulator maintains the desired system pressure in the upstream pipeline.
Bypass pump protects your pump for disassembly by allowing traffic to Bypass any obstacles in the line.
By applying pressure on the discharge, the performance of the pump is improved. Anti-
Siphon prevents chemicals from sucking away unwanted through your pump.
While there are other types of valves to choose from, it is recommended that you stick to the industrial high pressure safety valves as they are widely used and popular.
They feature small size and are easy to set up, adjust and install.
Custom message
Chat Online
Chat Online
Chat Online inputting...